Products

SMH series –
Cartridge Holder

A cartridge containing liquid is attached to the holder to pump liquid under pressure, and the system is formed in combination with a dispenser, valve, and liquid drip prevention valve.
The holder is made of stainless steel and has a slit at the bottom so that the remaining amount can be visually confirmed.

After attaching needle adapters (UNA series), tube fittings, dripping prevention valves, etc. to the cartridge, various needles and tubes can be attached and used. There is also an optional holder with a liquid level sensor that shows the remaining amount in the cartridge.

In case that the larger capacity is needed than the barrel method, 170/340cc cartridge type is available.
The cartridge which contains the fluid is loaded in the metal holder, and the fluid is pressurized and dispensed. The system consists of the dispenser, valve and the fluid dripping preventing valve.
The cartridge maybe discarded depending on the fluid.

Holder With Fluid level Sensor (SMH Type)

This is a holder system that detects the material in the cartridge and outputs a signal.

-It is a magnetic proximity switch that scrapes off the material cleanly by inserting a magnetic plunger in the cartridge and at the same time detects it at the set place. It can be used as an automation facility.

● The sensor position can be set arbitrarily, and multiple sensors can be installed if necessary.

● The applicable materials are mainly medium and high viscosity materials that do not harden naturally.

Model	Name	Material
SMH170N	170cc Holder	SUS304
SMH340N	340cc Holder	SUS304
SC170	170cc cartridge	Polyethylene
SC340	340cc cartridge	Polyethylene
SCP-1N	Plunger	Polyethylene
SCP-2	Cap (top)	Polyethylene
SCP-3	Screw-in plug	Polyethylene
SCP-4	Plug-in plug	Polyethylene