Products

DV55D

The use of a constant-bleed regulator improves pressure stability.
In combination with various barrels and metering valves, it can be used in a wide range of systems.
In the barrel system, the 55D series has a digital three-digit dispensing timer, which allows for finer dosing time settings and easier standardization.

Equipped with a discharge input signal retention circuit.
Discharge end signal output is standard equipment.
Stable discharge from minute amounts is possible with the solenoid valve high-speed operating circuit.
Stainless steel chassis is resistant to stains such as adhesives, and can be kept clean forever.
From low viscosity materials such as water to high viscosity materials, it is possible to discharge from 0.0001cc/shot to any desired large amount.
By combining with a discharge valve, it can be used with a wide range of systems.
Discharge can be confirmed by pressing the test switch on the panel.
The discharge timer can be set digitally. (Standard 0.01 to 9.99 seconds)
The timer range can be increased by one digit by switching the internal switch. (Maximum 0.1 to 99.9 seconds)

Control Method	Pneumatic – Electronic Control
Pressure Setting Range	0.01 ～ 0.7MPa
Power	AC100V ±10% 50/60Hz
Power Consumption	7VA or less
Mode of Operation	Timer Mode (Fixed Volume Dispensing )
	Free Mode (Constant Dispensing)
	Switching
Timer	0.01 ～ 9.99 sec (Digital Setting)
Maximum Shots	400 shots/min
External dimensions	180 (W) x 170 (D) x 81 (H) mm
Weight	1.9kg
Vacuum Function	Built-in
Dispensing End Signal (Relay Output)	MAX 125V, MAX 1A, MAX 30VA
Standard Accessories	Power Cable, Foot Switch (FSO1) or Metal Outlet (MC1604P)
Note	AC200V, AC220V, AC240V are also available